The file in this directory, ORBQUAKE.EXE, is a self-extracting ZIP

archive file containing a patch to update to version 1.06 of Quake

and to add the driver for the SpaceOrb 360. 



To install the software :



1) Download this file to your Quake directory, and type ORBQUAKE

   at your DOS prompt to uncompress the files. Answer yes to the 

   overwrite prompts.



2) To set up the SpaceOrb button mapping for Quake, copy the 

   uncompressed file, CONFIG.CFG, to the \QUAKE\ID1 directory.



NOTE: To keep your existing button maps and setup, AND map the

SpaceOrb 360 buttons, DO NOT copy over the CONFIG.CFG file. Instead,

use the Customize Controls screen in Quake (under the Options Menu),

choose the desired action by scrolling down and pressing ENTER, and

then press the corresponding button on the SpaceOrb 360. Altenatively,

use the BIND AUXn {Action} command at the console prompt, where AUXn

represents buttons AUX1-AUX6 (A-F) on the SpaceOrb, and {Action} is 

Attack, Jump, Change Weapon etc.



3) Run PATCH.EXE. This will update your PAK0.PAK file to support 

   the new version. 



Note: If you already have Quake 1.06 or higher, you do not need to 

run the PATCH.EXE program to upgrade Quake.



4) Run Quake with the SpaceOrb 360 from the DOS game Launcher:



Note: Since Quake is a DOS based game, you need to make sure that you 

have installed the SpaceWare RealLife 3D Software for DOS.  For the 

SpaceOrb 360 to run with Quake, you must have the SpaceOrb 360 DOS

drivers loaded.



These instructions assume that you have installed the SpaceOrb 360

software in the default directory. If not, you must edit QUAKE.BAT and

change the appropriate directories. Also it is assumed the game Quake

was installed in c:\games\quake.  If your game is stored in a different

location you must edit the file QUAKE.BAT and change the games directory

appropriately.  You must edit the file prior to copying it.



1.  Copy spwquake.* c:\spcware\spaceorb\games\*.*

2.  Copy quake.bat c:\spcware\spaceorb\games\*.*



To add Quake to the SpaceOrb DOS game launcher menu, edit the file

SPCWARE.CFG in the \SPCWARE\SPACEORB\SUPPORT directory, and add this

line:



Quake=C:\SPCWARE\SPACEORB\games\quake.bat.



NOTE: If this line is the last line in the SPCWARE.CFG file, you must

leave a blank line beneath it. After typing in the Quake line, press

Enter to create that blank line.



Running QLaunch for Windows 95:



To enable TCP/IP support for Quake in Windows 95, open a DOS

window, change to the Quake directory, and run the Q95.BAT file.



If you have installed the SpaceOrb software in a directory other

than the default \SPCWARE\SPACEORB, you must edit the file 

SPWBAT.BAT in the Quake directory, and change the path designations

to specify the directory in which you have installed the software.